Shopping cart

Your cart is currently empty

Product image slideshow Items

  • COLORAMICS, LLC MAYCO CHUNKIES EL-211 VOLCANIC GLOW
  • COLORAMICS, LLC MAYCO CHUNKIES EL-211 VOLCANIC GLOW

MAYCO CHUNKIES EL-211 VOLCANIC GLOW

Article number: EL211P
$22.15
Incl. tax

Cone 06 oxidation: Volcanic Glow is a glossy, dark grayish taupe glaze. It has large red crystals.
Cone 6 oxidation: Base glaze changes to brown/gold and breaks over texture; crystals melt and are red/blue.

In stock
swap-horizontal Add to compare

TIP: At cone 6: Enhanced mobility, surface issues may occur. This glaze WILL move. Take care when using on vertical pieces reduce glaze thickness towards the bottom third to minimize run-off. This glaze will pinhole at three coats. Not overglaze compatible.

MAYCO CHUNKIES EL-211 VOLCANIC GLOW has been certified as AP Non-Toxic, safe for use by artists of all ages when used according to manufacturer’s directions. However, they are not recommended for dinnerware as the fired finish is not chemically durable and can be impacted by contact with liquid or food. Additionally, if your ware exhibits textured surface issues such as cracks or crazing, attempts to adequately clean the surface may cause the underlying low-fire porous ware to absorb water and fail. Recommended for ornamental use only.

Inspired by aspects of nature, Elements™ and Elements™ Chunkies produce lush, organic, and earthy hues. Designed to simulate the look of mid-range glazes in a cone 06/05 oxidation kiln firing. May be used for all over coverage or in design, used alone or in combination with other Mayco glazes.
 
Shake for five to six seconds before use. Dispense glaze onto a palette (tile, plate, etc.) and apply with a soft brush or decorating accessory of choice (sponge, stamp, etc.). Dipping your brush directly into the jar may contaminate the jar’s contents, especially if you are using other glazes. Apply three to four coats to your piece. Elements™ glazes were designed to mature at a shelf cone 06 (999° C or 1830º F). When applying them over a large surface area, we recommend a broad, soft fan brush.

Moisten the brush with water first. The brush fully saturated (loaded) and each coat applied in the same direction. When the wet look has gone from the first coat, you may apply the next coat of glaze. Be sure the glaze has dried thoroughly prior to firing. A medium ramp/firing rate is recommended (250°F per hour) at shelf cone 06. Elements™ can be fired at higher temperatures but will change in appearance. We recommend testing prior to use.

 

CHARCOAL / CRYSTAL / ELEMENTS / LOW FIRE