Shopping cart

Your cart is currently empty

Product image slideshow Items

  • COLORAMICS, LLC MAYCO EL-130 SEA GREEN
  • COLORAMICS, LLC MAYCO EL-130 SEA GREEN

MAYCO EL-130 SEA GREEN

Article number: EL130P
$15.50
Incl. tax

Cone 06 oxidation: Sea Green is a glossy teal glaze that breaks dark blueish teal at three coats. It has an orangish brown stain.
Cone 6 oxidation: Color changes to a semi-translucent, variegated olive teal that breaks over texture and pools blue.

In stock
swap-horizontal Add to compare

TIP: This glaze WILL move. Take care when using on vertical pieces reduce glaze thickness towards the bottom third to minimize run-off. Overglaze compatible. At cone 6: Enhanced mobility. Surface issues may occur.

MAYCO EL-130 SEA GREEN is certified as AP Non-Toxic, safe for use by artists of all ages when used according to manufacturer’s directions. These glazes also meet Food Safe regulations as set by the FDA and are considered dinnerware safe when used according to manufacturer’s directions as the surface is chemically durable, and they do not exhibit textured surface issues.

Inspired by aspects of nature, Elements™ and Elements™ Chunkies produce lush, organic, and earthy hues. Designed to simulate the look of mid-range glazes in a cone 06/05 oxidation kiln firing. May be used for all over coverage or in design, used alone or in combination with other Mayco glazes.
 
Shake for five to six seconds before use. Dispense glaze onto a palette (tile, plate, etc.) and apply with a soft brush or decorating accessory of choice (sponge, stamp, etc.). Dipping your brush directly into the jar may contaminate the jar’s contents, especially if you are using other glazes. Apply three to four coats to your piece. Elements™ glazes were designed to mature at a shelf cone 06 (999° C or 1830º F). When applying them over a large surface area, we recommend a broad, soft fan brush.

Moisten the brush with water first. The brush fully saturated (loaded) and each coat applied in the same direction. When the wet look has gone from the first coat, you may apply the next coat of glaze. Be sure the glaze has dried thoroughly prior to firing. A medium ramp/firing rate is recommended (250°F per hour) at shelf cone 06. Elements™ can be fired at higher temperatures but will change in appearance. We recommend testing prior to use.

AQUA / ELEMENTS / LOW FIRE / SEA