TW Twig Hand Rollers are 3 inches (7.5 cm) long and 0.4 inches (1 cm) in diameter. You simply roll the TW roller with your hand across the clay or up the wall of a pot to create a beautiful pattern in any clay.

The two ends can be used to clean small and large openings in greenware. This brush can even be used to clean your own brushes.

One custom silkscreened underglaze rice paper transfer sheet for use on greenware or bisque pottery.

Made from flexible, thin, spring stainless steel, Kemper Steel Scrapers are used for shaping, smoothing, and trimming pottery shapes

Used for shaping, smoothing and trimming pottery shapes.

The WT6 Wood tool is commonly used on the potter's wheel to trim away excess clay at the bottom of thrown work. Also a handy sculptors blocking tool with it's long sharp wood knife edge and flattened rounded end.

Sharp, polished wood and steel hole cutters provide an easy method for cutting clean holes in wet, thick-walled greenware and clay. Can also be used for creating designs.

Orton’s patented Self-Supporting Cones are the most accurate and easy to use witness cones available. Since the correct height and angle are built into the cone, reproducible firings can be achieved time after time.

Large Pyrometric Cones allow users a practical method to monitor the heat work (the effect of temperature and time at temperature) inside their kiln.

One custom silkscreened underglaze rice paper transfer sheet for use on greenware or bisque pottery.

One custom silkscreened underglaze rice paper transfer sheet for use on greenware or bisque pottery.

One custom silkscreened underglaze rice paper transfer sheet for use on greenware or bisque pottery.

The Shape 2 Stainless Rib (SS2) is a workhorse for throwing, smoothing and compressing. In the Mudtools family, this shape was one of the firstborn in the tool series.

For when you really want to sink your teeth into your clay, grab all three large FANGS as a set! Everyone’s clay is different--some are fine, some are gritty. The FANG series of scoring tools allow you to find the right tooth size for your clay!

The flat bottom of this pottery tool allows you to steady it against your bat while the small cutouts at the ends create a rounded foot at the base of your clay vessel while it's still spinning the wheel.

Modeled after a slab roller these cloisonné enamel pins are the cutest! They come on an info card and measure about 1.5" at the widest point.

#10/0 LINERCB-110 Liners are the best choice for precise glaze placement. Liners provide maximum control for the creation of delicate lines.

The Mudshark is designed to combine the two tools most commonly used when throwing pots: a needle tool to trim the rim at the top and a fettling knife to cut away the waste at the base.

Texture 7 helps you create subtle waves in small, medium, and large sizes. Each side provides a different pattern that allows you to make a unique yet consistent texture on your vessel or slab and develop new forms in your work. Size: 3.5" x 3.25"